| Type |
Size Conn. O.D.S |
Flow Capacity Tons |
DIA øA |
B |
C |
Installation |
Volume (L) |
CE Cat. |
| Vertical |
Horizontal |
| CM-H2203-CE |
3/8" |
2 |
2 |
5.47 |
7.36 |
ˇ |
× |
0.34 |
SEP |
| CM-H2204-CE |
1/2" |
3 |
5.47 |
7.36 |
ˇ |
× |
0.34 |
| CM-H2205-CE |
5/8" |
5 |
5.47 |
7.36 |
ˇ |
× |
0.34 |
| CM-H2305-CE |
5/8" |
5 |
3 |
6.3 |
7.48 |
ˇ |
ˇ |
0.65 |
| CM-H2307-CE |
7/8" |
7.5~10 |
8.27 |
11.42 |
ˇ |
ˇ |
0.85 |
| CM-H2311-CE |
1 1/8" |
10~15 |
10.24 |
13.38 |
ˇ |
ˇ |
1.06 |
| CM-H2411-CE |
1 1/8" |
10~15 |
4 |
9.65 |
13.19 |
ˇ |
ˇ |
1.77 |
Ⅰ |
| CM-H2413-CE |
1 3/8" |
10~25 |
10.83 |
14.76 |
ˇ |
ˇ |
1.99 |
| CM-H2415-CE |
1 5/8" |
25~50 |
14.76 |
19.09 |
ˇ |
ˇ |
2.71 |
| Max . Permissible pressure: |
41.35 bar , ( 600psi )/-10°C~+150°C
31.03 bar , ( 450 psi )/-45°C~-10°C |
Unit : inch |
Mufflers are suitable for use with all refrigerants. Discharge line mufflers reduce gas pulsations but do not prevent the transmission of mechanical noise or vibration. You may briefly close-off the suction line, if the noise is reduced then pulsations are the cause and a muffler the best solution.
Select a muffler with a connection size that matches or exceeds the line size of the discharge line. There is no tonnage ratings for mufflers, since the muffler will remove pulsations from the discharge regardless of flow.
Depending on the models, mufflers could be installed in horizontal or vertical position. When mounted in the horizontal position, the inlet/outlet should be assembled on the bottom to insure proper flow of the oil (see Fig.1). The outlet should be lower than the inlet when possible, or the muffler may collect oil from the discharge and fill up which will reduce its muffling ability and cause loss of oil in the compressor crankcase. Mufflers that are mounted vertically will not trap oil.
